[Jun 04, 2023] Get Latest and 100% Accurate NACE-CIP1-001 Exam Questions [Q39-Q54]

NO.39 The Inspector should record the serial numbers of inspection instruments:

NO.40 Checking is

NO.41 A NACE Coating Inspector is permitted to transport coating material when:

NO.42 Good records can provide maintenance departments with detailed information about ALL of the following EXCEPT

NO.43 Surface profile describes:

NO.44 The initial steel condition is important to the NACE Inspector because:

NO.45 What is the minimum spot measurement value allowed by SSPC-PA 2 in each 10 m2 (100 ft2) area?

NO.46 Prior to the pre-job conference you notice that the Inspection and Test Plan does not require a hold point after surface preparation and coating application. In speaking with the owners’ representative in advance of the meeting you sense he/she does not understand the importance of the hold point.
As a NACE CIP Level 1 Inspector your preferred course of action is to:

NO.47 What is used to determine compressed air cleanliness?

NO.48 ISO SA 3 is directly equivalent to:

NO.49 You are the NACE Inspector on a 5000 sq. ft. job where SSPC PA 2 has been specified.
Assuming all areas are in compliance, how many gauge readings and spot measurements are required?

NO.50 Osmotic blistering is most likely to occur as a result of

NO.51 Excessive working of the surface with a power grinder can be detrimental because excessive burnishing

NO.52 You have just received your NACE CIP Level 1 certification when you are asked to supervise a team of uncertified field pipeline inspectors.
Your FIRST preferred course of action is to:

NO.53 Which of these tests uses a syringe?

NO.54 Prior to using Inspection Tools the inspector must: