Download Free NACE NACE-CIP1-001 Exam Questions & Answer [Q43-Q67]

NO.43 Surface profile describes:

NO.44 Inspector’s daily reports are used:
Select All That Apply

NO.45 You have just received your NACE CIP Level 1 certification when you are asked to supervise a team of uncertified field pipeline inspectors.
Your FIRST preferred course of action is to:

NO.46 The primary difference between Non-Convertible vs. Convertible coatings is:

NO.47 Digital hygrometers

NO.48 ISO SA 2.5 is defined as:

NO.49 Daily reports are important because:
Select All That Apply

NO.50 An Inspector should change position when:

NO.51 Prior to using Inspection Tools the inspector must:

NO.52 A successful coating inspector must be able to

NO.53 Due to a previous premature coating failure the owner has required the original coating applicator to return to remove and replace 10,000 square feet of a failed three coat system at the applicator’s cost. Due to the financial implications of another failure, the owner has offered you the job as the NACE CIP Level 1 Coating Inspector and explained that he expects you to be his “insurance policy” for this job. You have never been involved in a warranty job before and are unfamiliar with the coating system.
Your preferred FIRST course of action is to:

NO.54 ISO SA 3 is directly equivalent to:

NO.55 Checking is

NO.56 Prior to the pre-job conference you notice that the Inspection and Test Plan does not require a hold point after surface preparation and coating application. In speaking with the owners’ representative in advance of the meeting you sense he/she does not understand the importance of the hold point.
As a NACE CIP Level 1 Inspector your preferred course of action is to:

NO.57 Stripe coats are generally applied to:

NO.58 Solvents are added to coating formulations to

NO.59 How many gauge readings does SSPC-PA 2 require within a 4 cm (1.5 inch) diameter circle?

NO.60 Safety Data Sheets must be carefully reviewed by:

NO.61 You are the NACE Inspector on a tank lining project where a 50% solids epoxy tank lining is being applied. After application of the 19 coat you notice small blisters in some areas of the applied lining.
Your FIRST preferred course of action is to:

NO.62 The most important factor resulting in improved job site safety is:

NO.63 Removal of surface contaminants is done by:

NO.64 SSPC SP 1 identifies the use of:

NO.65 When holiday testing is required the Inspector is always required to enforce NACE SP 0188:

NO.66 To achieve consistently accurate results with ALL alt test equipment

NO.67 Most industrial coatings are: