HPE6-A72 Exam Dumps Pass with Updated 2023 Certified Exam Questions [Q22-Q41]

Q22. Interface 1/1/1 is up
Admin state is up
Link transitions: 1
Description: TO_PC-1
Hardware: Ethernet, MAC Address: 00:11:22:33:44:55
MTU 1500
Type 1GbT
Full-duplex
qos trust none
Speed 1000 Mb/s
Auto-negotiation is on
Flow-control: off
Error-control: off
MDI mode: MDIX
VLAN Mode: access
Access VLAN: 1111
Which command will produce the above output?

Q23. Refer to the exhibit.

The above command was applied to an Aruba AOS-CX 6300M 24-port switch with 4-port SFP56 uplinks. All ports are set as access switchports.
Which ports carry VLAN 1 traffic?

Q24. The following command is issued:
Switch# checkpoint rollback start
What is the result?

Q25. Refer to the exhibit.

The above output is the result of issuing the command show system resource-utilization.
What command should be used to enable terminal output line by line or page by page?

Q26. Which port or ports should be allowed through a firewall so that an AOS-CX switch can act as an SNMP Agent?

Q27. The section in blue can be ignored.
SW1(config)# interface 1/1/1-1/1/2
SW1(config-if-<1/1/1-1/1/2)# vlan access 2
SW1(config-if-<1/1/1-1/1/2)# exit
SW1(config)# interface 1/1/11-1/1/17
SW1(config-if-<1/1/11-1/1/17)# vlan access 17
SW1(config-if-<1/1/11-1/1/17)# exit
After completing the above commands, what is the expected output of show vlan with no other vlan commanded having been added?

Q28. Which two statements accurately describe stacking with Aruba switches? (Choose two.)

Q29. Review the exhibit.
As the frame traverses from **PC-1** to **Server-1**, the VLAN tag will be removed.
Click on the interface (circled in green) where the VLAN tag will be removed.

Q30. Refer to the exhibit.

Traffic is failing between Core-1 and Host-B. IP addressing has correctly been applied, and all interfaces are attached to the vrf GREEN.
Which configuration will correct the issue?

Q31. Refer to the exhibit.


What command will display the debug l2mac events?

Q32. With what other technology does Half Duplex communication closely match?

Q33. What command will save your configuration on an Aruba AOS-CX switch so that your changes automatically load on next reboot?

Q34. Refer to the exhibit.

The Aruba 8400 in the exhibit is member 2 of a VSX stack.
Which command will enter the interface sub configuration mode for the port, indicated by the orange square?

Q35. Which field in the IPv4 header indicates whether the IP packet carries TCP or UDP traffic?

Q36. Refer to the exhibit.

Using the static IP address configured above, what is the converted binary value of the third octet assigned to the local interface?

Q37. What is a benefit of choosing a 3-Tier design with routing at the Aggregation layer?

Q38. Which command can be used to find the serial number of an Aruba OS-CX switch?

Q39. Refer to the exhibit.

All four switches in the diagram have been configured with the region name “Aruba1”.
What two other MSTP configurations must match for switches within the same MST region? (Choose two.)

Q40. Which statement is correct regarding powering an Aruba Access Point?

Q41. SW1(config)# interface 1/1/1-1/1/2
SW1(config-if-<1/1/1-1/1/2)# vlan access 2
SW1(config-if-<1/1/1-1/1/2)# exit
SW1(config)# interface 1/1/11-1/1/17
SW1(config-if-<1/1/11-1/1/17)# vlan access 17
SW1(config-if-<1/1/11-1/1/17)# exit
After completing the above commands, what is the expected output of show vlan with no other vlan commanded having been added?