Aug-2026 Huawei H12-323_V2.0 Actual Questions and Braindumps [Q103-Q119]

NO.103 In the dual-link hot backup scenario, the authentication information of 802.1x authentication, MAC authentication and Portal authentication can be backed up. After the active and standby WACs are switched, wireless users using these authentication methods do not need to re-authenticate.

NO.104 The engineer deployed a wireless environment in the customer’s existing network. After completing the AP online and service configuration on the wireless controller, he used the terminal to associate the signal and found that the corresponding SSID could not be searched.
Which of the following is NOT the cause of this problem?

NO.105 In the inter-WAC roaming scenario, different WACs can be grouped, and STAs can roam between WACs in the same group. An AC can serve as a roaming group server for multiple roaming groups at the same time, but can only join one roaming group itself.

NO.106 As shown in the figure, this is a WLAN network diagram deployed by an enterprise using a Mesh networking architecture.

The network contains multiple devices. Which of the following devices has the portal function?

NO.107 When planning WLAN in medium and large networks, in order to prevent the WLAN broadcast domain from being too large and causing broadcast storms, the single service VLAN broadcast domain should be kept as small as possible.

NO.108 The customer’s existing network has configured inter-WAC roaming. The engineer checked the information of the roaming group on the wireless controller and found the following description of the roaming group. Which one is wrong?

NO.109 In a VLAN network, what are the stages of STA access? (Multiple choice)

NO.110 In the “Manufacturer Customization” page of the ClouCaspus APP, WLAN project delivery engineers can use the “Hardware Quality Inspection” function to check whether the installed hardware devices meet the hardware installation standards.

NO.111 Drag and Drop Question
Please match the authentication function template on iMaster NCE-Campus with its function.

NO.112 A company has deployed multiple APs in its office area. To improve the convenience of network deployment, the user hopes that WAC will automatically assign channels to APs based on the wireless network environment, so the RF tuning function is configured. However, engineers found that the RF tuning did not take effect. Which of the following configurations might be the cause?

NO.113 Which of the following tools can be used by users to obtain project information from WLAN Planner through the CloudCampus APP on their mobile phones and view AP location and heat map information on the APP at any time?

NO.114 The dynamic bandwidth adjustment algorithm in Huawei’s wireless RF automatic tuning solution will adjust the bandwidth of the hotspot area upward to 40 MHz or 80 MHz according to the channel allocation to improve network throughput. However, when the network interference increases to a certain threshold, it will prioritize ensuring that the network is interference-free and reduce the bandwidth of the hotspot area.

NO.115 In the Portal authentication scenario, if there is no condition to deploy an external independent Portal server, the built-in Portal server of WAC can be used for authentication. Which of the following descriptions about the built-in Portal server is wrong?

NO.116 In the cloud campus network solution, iMaster NCE-Campus manages APs through the () protocol.

NO.117 Among the SISO, SIMO, MISO, and MIMO transmission systems on a WLAN, only MIMO can transmit two copies of signal simultaneously.

NO.118 As shown in the figure, this is a schematic diagram of AP channel planning for a certain enterprise floor, and the planning has been completed for some floors.

It has been confirmed that the 2.4G frequency band channels will be used for deployment, and co- channel interference must be avoided. Which of the following is the most reasonable channel planning for the third floor?

NO.119 In order to isolate visitor traffic and employee traffic, a large enterprise adopted the Navi AC networking architecture to deploy a WLAN network.
When configuring Local AC, which of the following descriptions is wrong?