[Jan-2026] 300-610 PDF Dumps Extremely Quick Way Of Preparation [Q109-Q126]

NEW QUESTION 109
A Cisco engineer is configuring MPLS VPN BGP at a customer site that is connected to the provider site by more than one path MPLS VPN BGP Local Convergence link protection is enabled. After the engineer installs the main forwarding path and the redundant backup path within the BGP, they assign a unique route distinguisher to each VRF table on all PE devices that serve as a backup to the link. What is a prerequisite for this local convergence to work?

NEW QUESTION 110
A customer asks an engineer to develop a framework to configure Cisco services that will be used to replace process of manual device configuration. The engineer plans to use a programmatic interface and must keep these considerations in mind:
– The customer’s environment requires the script to authenticate before executing further actions.
– The customer’s security requirements mandate the use of HTTPS
transport.
– The support stall has limited shell scripting knowledge, so the
scripts should be easy to read and write and be serf-documenting.
Which two solutions should be used to meet these requirements? (Choose two.)

NEW QUESTION 111
An engineer must connect an existing Cisco Fabric Interconnect to an IP-based storage array. The connection be a channel made directly between the fabric interconnect expansion module and the storage array. The engineer must also consider that the environment is running FCoE for storage and uses QoS to prioritize traffic. Which port type should be used to meet these requirements?

NEW QUESTION 112
Refer to the exhibit. A Cisco engineer is configuring a data center design scenario with Cisco MDS 90Q0 Series Switches. The cut-through routing mode is chosen for impf oved read operation performance. Each (SCSI host requires access lo storage through the IPS module. First, the engineer configures the TCP tuning parameters as enabled SACK, the maximum bandwidth of 1 Gbps. buffer size of 4096. keepalive timeout at 1s. and enables Path MTU. Then, the engineer must set the OoS of the ISCSI link. What is the maximum QoS value that must be set tor the ISCSI session?

NEW QUESTION 113
Refer to the exhibit.

The FCoE packets fail to be forwarded through the switch. What is the minimum MTU QoS requirement for the FCoE to work?

NEW QUESTION 114
Refer to the exhibit. Two Cisco Nexus 9000 Series Switches exchange OSPF routing information with R1. Which action accomplishes this goal?

NEW QUESTION 115
An engineer must use a template to add Fibre Channel SAN connectivity to Cisco UCS B-Series servers. Any changes made to this template in the future must propagate to all servers. Which template must the engineer choose?

NEW QUESTION 116
An engineer must design a solution with storage reachability between 100 physical servers and a storage array. The storage array connectivity is to a SAN switch that is limited to 48 ports. Which topology meets the requirements without adding more MDS switches?

NEW QUESTION 117
An organization deploys Cisco UCS-X Series servers in the data center. The deployment must have optimal BIOS configuration to maximize performance for memory-intensive applications. The organization must set the BIOS options to achieve low-latency operation and enhanced memory bandwidth. Which BIOS tuning option on Cisco UCS-X Series servers is needed for memory-intensive workloads?

NEW QUESTION 118
An engineer must deploy a Cisco HyperFlex system at two data centers. For redundancy reasons, the setup must achieve data protection in case of an entire site failure. The data must be available on both sites at all times to keep the recovery time objective to a minimum.
Which Cisco HyperFlex deployment model meets these requirements?

NEW QUESTION 119
Drag and drop the Cisco Nexus 7000 Series Switch resources from the left onto the correct groups on the right.

NEW QUESTION 120
Refer to the exhibit. A high-availability setup for iSCSI is designed with the host running iSCSI multipath software. Each IP storage port on the MDS switch exports the same two Fibre Channel target ports with different iSCSI target names.

In this design, how many iSCSI sessions are created from the host so that recovery occurs if any component fails?

NEW QUESTION 121
Drag the requirements from the left onto the correct policy types on the right.

NEW QUESTION 122
Drag the appropriate from the left onto the current UDLD modes of operation on the right.

NEW QUESTION 123
Refer to the exhibit.

NEW QUESTION 124
A Cisco engineer is preparing a service profile template for a design, which consists of 20 x UCS B200M6 blade servers 2 x UCS 6454 Fabric Interconnect in End Host Mode, and 3 x UCS 5108 server chassis with 2408 Fabric Extenders The blade servers are equipped with VIC 1480 adapters The engineer does not configure a vNIC/vHBA placement policy in the service profile and the vNICs and vHBAs are assigned to the vCon in a particular order What is the mapping scheme in which Cisco UCS assigns the vCons based on the type of server and the selected virtual slot?

NEW QUESTION 125
Drag and Drop Question
Drag and drop the configurations from the left onto the correct policies on the right.

NEW QUESTION 126
An enterprise is experiencing transmission errors and excessive deploys over their WAN when backing up user workstations. A systems architect decided to resolve the problems by centralizing data storage and processing to within the confines of the data center. Which technology is most suitable to mitigate the issues?