[May-2022] The Best HCIP Transmission H31-341 Professional Exam Questions [Q71-Q89]

NEW QUESTION 71
Which of the following subracks does not support the configuration of packet board?

NEW QUESTION 72
After the signal of the standard Ethernet frame length of 64 Bytes is connected to the Ethernet board, if the QinQ function is enabled, what is the actual frame length of the signal inside the board?

NEW QUESTION 73
The ways of synchronize alarms are (). (Multiple Choice)

NEW QUESTION 74
What does the component of the ASON network not include?

NEW QUESTION 75
During the configuration of the E-LAN, the “MAC Address Learning Mode” can be set to SVL and IVL. SVL is a stand-alone VLAN learning, and IVL is a shared VLAN learning.

NEW QUESTION 76
What are the classification of Ethernet performance tests? (Multiple choice)

NEW QUESTION 77
The following protection methods belonging to NG WDM optical layer protection are: (Multiple Choice)

NEW QUESTION 78
Which of the following trails can be configured on the NMS.

NEW QUESTION 79
In the sub-(wave) characterization test, what kind of standard does the isolation test require?

NEW QUESTION 80
Before creating an optical cross-connection, you need to manually configure the corresponding port of the corresponding board as a boundary port, for example, the line-side port of the FIU board between two sites.

NEW QUESTION 81
In the scenario where the non-convergence OTU processes OTN standard signals, both A and B are WDM sites. After receiving the OTUk_TIM alarm on the client side, the OTU board at station A sends the OTUk_BDI alarm to the upstream. When the TIM follow-up action is disabled, the alarm is no longer transmitted to the downstream. When the TIM follow-up action is enabled, an SF event is generated. The WDM side of the OTU board at station B reports the ODUk_PM_AIS alarm, and the ODUk_PM_AIS alarm is transmitted downstream. The client equipment reports this alarm. After the WDM side of the OTU board at station B receives the OTUk_TIM alarm and the TIM follow-up action is disabled, the alarm is no longer transmitted to the downstream. When the TIM follow-up action is enabled, an SF event is generated. After the client side of station B processes the SF event, the client equipment reports the ODUk_PM_AIS alarm.

NEW QUESTION 82
What are the wavelengths of the OSC channel used by the ST2 board?

NEW QUESTION 83
When configuring the Ethernet Layer 2 attribute, set the Default VLAN ID and VLAN Priority of the untagged frame when the TAG ID is set to Accese or Hybrid. The “VLAN priority” is set according to the QoS of the unified plan.

NEW QUESTION 84
In the WDM system, after a certain distance of transmission, the optical signal-to-noise ratio of the receiving signal will be reduced to a certain extent. What is the main reason?

NEW QUESTION 85
Which of the following statements about the line fiber quality monitoring performance parameters is wrong?

NEW QUESTION 86
Which of the following monitoring boards do not support the processing and transparent transmission of 1588V2 signals? (Multiple choice)

NEW QUESTION 87
Which of the following description is wrong about the content of the formula for calculating the maximum line rate (N=Ratc/((L+7+1+M)x8))?

NEW QUESTION 88
Which of the following scenarios does the meter test apply to? (Multiple choice)

NEW QUESTION 89
What should I pay attention to when commissioning a 100G and 10G hybrid transmission system? (Multiple Choice)