[Q24-Q44] Get up-to-date Real Exam Questions for NETA_2 UPDATED [2026]

NO.24 On an electrical schematic, adot on a current transformer symbolindicates:

NO.25 Which instrument is used tolocate a fault in a 15 kV underground cable?

NO.26 What is the primary advantage ofaluminum bus barcompared to copper?

NO.27 When may anunqualified personenter theLimited Approach Boundary?

NO.28 A digital multimeter (DMM), when set to measure voltage, typically has which type of input impedance?

NO.29 Following an insulation resistance test on a motor circuit, what procedure is required to safely return the circuit to a neutral charge state?

NO.30 Using a typical breaker control diagram, which coil is most commonly associated with theanti-pump function
?

NO.31 The smallest particle of a substance that still retains the properties of that substance is a:

NO.32 A ground conductor is routed through azero-sequence current transformer (CT)together with the phase conductors feeding the load. What is the most likely result?

NO.33 A 120 VDC circuit draws0.83 amperes. How much power is consumed?

NO.34 ASTM D 924 is a required acceptance test for liquid-filled transformers containing natural ester insulating fluid according to NETA standards.

NO.35 A1500:5 multi-ratio CTproduces400 Vat the1200:5 tapduring saturation testing. What voltage is expected at the1500:5 tap?

NO.36 Which ANSI device number corresponds to anundervoltage relay?

NO.37 What is meant by adead-tank circuit breaker?

NO.38 A delta-connected load has aphase impedance of 12 #and is supplied from a480 V line-to-line source. What is theline current?

NO.39 Evaluate the expression:

NO.40 What is themaximum allowable deviationbetween resistance measurements on bolted electrical connections?

NO.41 The three-phase connection in whichone end of each winding is connected togetheris called which configuration?

NO.42 What is theRestricted Approach Boundaryfor a69 kVsystem?

NO.43 On a circuit breaker equipped with a solid-stateLSIGtrip unit, what does the”I”represent?

NO.44 Each switchboard used asservice equipmentmust be provided with amain bonding jumper.