Guaranteed High Marks with Updated & Real FCSS_LED_AR-7.6 Dumps pdf Free Updates [Q29-Q51]

Posted On February 24, 2026

Guaranteed High Marks with Updated & Real FCSS_LED_AR-7.6 Dumps pdf Free Updates

PASS RATE Fortinet Certified Solution Specialist FCSS_LED_AR-7.6 Certified Exam DUMP

NEW QUESTION 29
What are the advantages of dynamic VLAN assignment in LAN edge designs?
(Choose two)
Response:

Reduces configuration effort for mobile users

Hard-codes VLANs to interfaces

Improves scalability and policy enforcement

Disables STP on access ports

NEW QUESTION 30
Refer to the exhibits.
FortiGate RSSO configuration

FortiGate RSSO Group

FortiGate interface configuration

RSSO authentication has been configured on FortiGate. Port3 has been enabled to receive RADIUS accounting messages. Internet access is available through port1. FortiGate is successfully handling incoming RADIUS accounting messages, ensuring that RSSO users are correctly mapped to the RSSO Group user group. The administrator realized that internet access is open to all users and aims to enforce access restrictions, ensuring that only RSSO users are permitted to have internet access. Which configuration change should the administrator apply to address this issue? Response:

Change the RADIUS attribute value setting to match the name of the RADIUS attribute containing the group membership information of the RSSO users.

Create a second firewall policy from port3 to port1, and select the target destination subnets.

Configure a local user group and manually add users to enforce authentication-based restrictions.

Modify the firewall policy and add RSSO Group as a Source.

NEW QUESTION 31
When integrating FortiAuthenticator with an LDAP server, which parameter must be correctly defined to perform user lookups?
Response:

Group name

DN (Distinguished Name)

Shared secret

Syslog filter

NEW QUESTION 32
You are preparing FortiManager for ZTP. Which CLI command enables provisioning mode?
Response:

config system provisioning

set ztp enable

set allow-register enable

set central-mgmt enable

NEW QUESTION 33
Refer to the exhibits.

Examine the FortiGate configuration, FortiAnalyzer logs, and FortiGate widget shown in the exhibits.
Security Fabhc quarantine automation has been configured to isolate compromised devices automatically.
FortiAnalyzer has been added to the Security Fabric, and an automation stitch has been configured to quarantine compromised devices.
To test the setup, a device with the IP address 10.0.2.1 that is connected through a managed FortiSwitch attempts to access a malicious website. The logs on FortiAnalyzer confirm that the event was recorded, but the device does not appear in the FortiGate quarantine widget.
Which two reasons could explain why FortiGate is not quarantining the device? (Choose two.)

The IOC action should include only the FortiSwitch in the quarantine.

The SSL inspection should be set to deep-Inspection

The malicious website is not recognized as an indicator of compromise (IOC) by FortiAnalyzer.

The threat detection services license is missing or invalid under FortiAnalyzer.

NEW QUESTION 34
In FortiManager CLI, how do you enable FortiAIOps monitoring?
Response:

config system aiops → set enable

config system global → set ai-monitor enable

config aiops settings → set collection-mode full

FortiAIOps is enabled by default in managed mode

NEW QUESTION 35
You’re configuring FortiAuthenticator to authenticate users via LDAP. Which syntax correctly defines the LDAP query filter to retrieve users from a specific OU named “Engineering”?
Response:

(ou=Engineering)

(&(objectClass=person)(ou=Engineering))

(cn=Engineering)

(OU=Engineering,DC=example,DC=com)

NEW QUESTION 36
How does FortiAnalyzer contribute to device quarantine actions in a Fortinet Security Fabric?
Response:

Provides automatic endpoint disconnection

Triggers FortiAIOps remediation

Sends log-based event triggers to FortiGate

Reboots affected FortiSwitch ports

NEW QUESTION 37
To assign a captive portal to a guest SSID, which CLI command is used on FortiGate?
Response:

config wireless-controller vap

set security captive-portal

set portal-type guest

set auth-type captive-portal

NEW QUESTION 38
Which of the following are benefits of using FortiAIOps in large campus environments?
(Choose two)
Response:

Increased log retention

Faster mean time to resolution (MTTR)

Predictive alerting and diagnostics

License pooling

NEW QUESTION 39
Refer to the exhibit.

Which shows the WTP profile configuration.
The AP profile is assigned to two FAP-231F APs that are installed in an open plan area.
The first AP has 32 clients associated with the 5 GHz radios and 22 clients associated with the 2.4 GHz radio.
The second AP has 12 clients associated with the 5 GHz radios and 20 clients associated with the 2.4 GHz radio.
A dual-band-capable client enters the area near the first AP and the first AP measures the new client at – 3 3 dBm signal strength. The second AP measures the new client at -43 dBm signal strength.
If the new client attempts to conned to the student 01 wireless network, which AP radio will the client be associated with?

The first AP 2.4 GHz interface provides a stronger signal, which clients often prioritize.

The first AP 5 GHz interface because it has a stronger signal.

The second AP 5 GHz interface has fewer clients, which ensures better performance despite the weaker signal.

The second AP 2.4 GHz interface is preferred over 5 GHz for better speed and lower interference.

NEW QUESTION 40
A network administrator connects a new FortiGate to the network, allowing it to automatically discover andI register with FortiManager.
What occurs after FortiGate retrieves the FortiManager address?

FortiGate establishes a secure tunnel to FortiManager over TCP port 541.

The device needs to be manually authorized on FortiManager.

FortiGate configures its interface settings based on a DHCP response from FortiManager.

FortiGate sends a discovery request to all devices on the local network using UDP port 1068.

NEW QUESTION 41
Which three FortiAuthenticator configuration elements are involved in RSSO processing?
(Choose three)
Response:

RSSO Attribute

Group Mapping

Syslog Server

RADIUS Client

DNS Filter

NEW QUESTION 42
What is the primary requirement for FortiManager to manage a FortiSwitch via FortiGate using FortiLink?
Response:

FortiLink must be in trunk mode

FortiSwitch must have a static IP

FortiGate must be in transparent mode

FortiGate must be managed by FortiManager

NEW QUESTION 43
When the MAC address of a device is placed in quarantine on FortiSwitch, what happens to its egress traffic?

Traffic is sent to an access VLAN.

Traffic is assigned to the native VLAN.

Traffic is sent as untagged traffic.

Traffic is sent to an allowed VLAN.

NEW QUESTION 44
Which command verifies FortiExtender signal strength on a FortiGate CLI?
Response:

diagnose extender modem status

get extender status

show extender radio

diagnose wireless-controller wlac

NEW QUESTION 45
When configuring FortiLink in FortiManager to manage FortiSwitch, which of the following steps are mandatory?
(Choose two)
Response:

Configure switch controller in FortiGate policies

Apply provisioning template to FortiAP

Enable FortiLink interface on FortiGate

Import FortiSwitch configuration template into FortiManager

NEW QUESTION 46
Which features can be configured on a FortiGate for guest wireless access control using captive portals?
(Choose two)
Response:

Redirect to authentication page

Automatic MAC binding

Session expiration

OSPF area filtering

NEW QUESTION 47
Which three conditions can FortiLink NAC use to enforce network access control?
(Choose three)
Response:

MAC address

User identity

Switch stack priority

Device type

Interface MTU

NEW QUESTION 48
Which dashboard widget allows real-time monitoring of SSID usage and client count?
Response:

WiFi Clients

Interface Bandwidth

System Events

Device Inventory

NEW QUESTION 49
What insight can FortiAIOps provide that traditional monitoring systems cannot?
Response:

CPU and memory usage

Historical Syslog reports

AI-driven anomaly detection and root cause suggestions

VLAN configuration recommendations

NEW QUESTION 50
Which CLI automation action on FortiGate is used to define automatic quarantine based on event logs?
Response:

config system automation-action → set action quarantine

config log setting → set quarantine enable

config automation-stitch → set action-type quarantine-host

config user quarantine → set auto-log enable

NEW QUESTION 51
Which FortiGuard licenses are required for FortiLink device detection to enable device identification and vulnerability detection?

FortiGuard Vulnerability Management and FortiGuard Endpoit Protection

FortiGuard Threat Intelligence and FortiGuard loT Detection

FortiGuard Threat Intelligence and FortiGuard Endpoint Protection

FortiGuard Attack Surface Security and FortiGuard loT Detection