2022 352-001 Dumps PDF – 352-001 Real Exam Questions Answers [Q113-Q137]

NEW QUESTION 113
Refer to the exhibit.

A service provider would like to use Ethernet OAM to detect end-to-end connectivity failures between SP-SW1 and SP-SW2. In which two of these ways can you design this solution? (Choose two.)

NEW QUESTION 114
You are designing the QoS features for a large enterprise network that includes DMVPN. When would you need to configure QoS preclassify?

NEW QUESTION 115
What is the most common IoT threat vector?

NEW QUESTION 116
A company wants to use SSM as the multicast routing protocol inside its network. Some of its multicast applications do not support IGMPv3. In which two ways can the mapping be done when these applications send IGMPv2 join messages? (Choose two.)

NEW QUESTION 117
Your network operations team is deploying Access Control Lists (ACLs) across your Internet gateways They wish to place an ACL inbound on the Internet gateway interface facing the core network (the “trusted” interface). Which IP address would the ACL need for traffic sourced from the inside interface, to match the source address of the traffic?

NEW QUESTION 118
You are designing a FabricPath network that connects to a spine-and-leaf topology using layer 2 IS-IS as the IGP. The solution should be able to detect changes in the network topology and calculate loop-free paths to other nodes in the network that are being used as top-of-rack switches. Which four options are characteristics of this FabricPath design solution? (Choose 4)

NEW QUESTION 119
Flex Links are a pair of a Layer 2 interfaces (switchports or port channels), where one interface is configured to act as a backup to the other. Which two statements are correct regarding Flex Links?

NEW QUESTION 120
Refer to the exhibit,

Which two design considerations should be implemented on the pseudowire between N-PE and U-PE routers for a loop-free hierarchical VPLS service? (Choose two)

NEW QUESTION 121
What are three key design principles when using a classic hierarchical network model? (Choose three.)

NEW QUESTION 122
A network designer has provisioned a router to use IPsec to encrypt the traffic over a GRE tunnel going to a web server at a remote location. From the router, the network designer can ping the web server, although the users in the office comment that they are unable to reach it. (Note: The DF bit is not set.) Which aspect should be changed in the design of the virtual connection?

NEW QUESTION 123
You are the lead network designer hired by Service Provider XYZ to deploy CoS functionality on
the core MPLS network (P routers). The goal of the network design is to provide a complete CoS
solution to all customers that purchase services such as dedicated Internet access, MPLS L3VPN,
and L2VPN (pseudowire). Service Provider XYZ has these design requirements:
-The network supports four service queues with equal treatment for delay, jitter, and packet loss.
-Queues are numbered 0-3, where 0 is the default queue.
-Three queues have one treatment.
-One queue has either one or two treatments.
If your design includes eight CoS queues on the Service Provider XYZ MPLS PE router ingress
(CE facing) interface, how will customer traffic be classified as it enters the MLS P routers?

NEW QUESTION 124
You are redesigning an OSPF v2 network and must migrate some links. You are concerned that there are different subnet masks. Which two link types will still form an OSPF adjacency even if there are subnet mask mismatches? (Choose two.)

NEW QUESTION 125
You are designing an IPv4 any source multicast redundancy solution. Which technology ensures the quickest RP convergence?

NEW QUESTION 126
An enterprise company has an audit requirement to encrypt traffic between selected development teams. Those teams are located in multiple sites across the country. They must migrate all locations to an MPLS Layer 3 VPN-based service, but this implementations must not impact the VoIP traffic to and from the call centre sites must be copied to the data center servers so that it is recorded to meet another audit requirement, which solution meets these requirements?

NEW QUESTION 127
What are three key design principles when using a classic hierarchical network model? (Choose three.)

NEW QUESTION 128
Refer to the exhibit.

RTR 1 uses RTR 2 as the primary WAN exit point. When a failure occurs in the link connected to RTR 2 LAN, it takes about 40 seconds for RTR 1 to use the backup path via
RTR 3.
Which two mechanisms can be used independently to improve the failure detection time to
1 second or less when RTR 1 failover to RTR3? (Choose two.)

NEW QUESTION 129
An ISP provides VoIP and internet services to its customers. For security reasons, these services must be transported in different MPLS Layer 3 VPNs over the ISP core network. The customer CEs do not have the ability to segment the services using different VLANs and have only one uplink interface that does not support VLAN tagging. How should you design the network to ensure that VoIP traffic that is received from the CE goes in the VoIP VPN, and that Internet traffic goes into the Internet VPN on the ISP PE devices?

NEW QUESTION 130
AS100 and AS200 each have two peering points in different parts of their network. AS100 would
65
like to use one of the links and keep the other link as backup. What should be changed for the design inside AS100 for prefixes received from AS200?

NEW QUESTION 131
You are designing an Out of Band Cisco Network Admission Control, Layer 3 Real-IP Gateway deployment for a customer. Which VLAN must be trunked back to the Clean Access Server from the access switch?

NEW QUESTION 132
A company is planning to connect its 30 sites with a VPLS WAN backbone. A router at
each site should establish neighborships with all other routers using the OSPF routing protocol. Which three points must be considered regarding DR and BDR when different router platforms are used? (Choose three.)

NEW QUESTION 133
A switched network is being designed to support a manufacturing factory. Due to cost constraints, fiber- based connectivity is not an option. Which design allows for a stable network when there is a risk of interference from the manufacturing hardware in use on the factory floor?

NEW QUESTION 134
You are evaluating convergence characteristics of various interior gateway protocols for a new network design. Which technology allows link-state routing protocols to calculate paths to destination prefixes that are functionally similar to feasible successors in Enhanced Interior Gateway Routing Protocol?

NEW QUESTION 135
You are creating a network design that will influence the traffic path across the MPLS core on a virtual private LAN. Which parameter is included in your design to manage the traffic?

NEW QUESTION 136
Your company is designing a service provider network management solution in which customers are billed for 95th percentile network utilization. The service provider requires that an IETF standard be utilized to collect the data. Which method should be used to collect the data?

NEW QUESTION 137
DRAG DROP