Free EMC DES-DD33 Study Guides Exam Questions & Answer [Q28-Q45]

NO.28 What happens to the data when it is moved from the active tier to cloud tier?

NO.29 Which component of PowerProtect DD is Data Invulnerability Architecture a feature of?

NO.30 What is a main advantage of using DD Boost instead of CIFS or NFS for a backup?

NO.31 Which NDMP device is supported on a PowerProtect DD appliance?

NO.32 What is a requirement to use the PowerProtect DD HA feature?

NO.33 A PowerProtect DD system is configured for VTL. The backup application requires a minimum tape capacity of 800 GiB.
What is the minimum tape type to support this requirement?

NO.34 Which PowerProtect DD procedure uses the DoD/NIST standards to provide data security?

NO.35 How can remote logging with a syslog server be configured on a PowerProtect DD system?

NO.36 An administrator monitors the performance statistics of a PowerProtect DD appliance. Low disk-write rates are shown, and the network inbound traffic is high.
What is the most likely cause of this behavior?

NO.37 What are all the protocols that can be used to send data to a PowerProtect DD over Ethernet?

NO.38 What is the correct sequence of operations used by the PowerProtect DD DIA in the end-to-end verification process?

NO.39 A PowerProtect DD appliance has been installed at a company’s location for several months and has reached a steady state.
As a best practice, at what percentage of disk utilization should action be taken?

NO.40 A backup administrator is tasked with monitoring PowerProtect DD capacity metrics. The administrator is backing up 2 TB of data daily with a reduction rate at 5x. After data reduction, subsequent full backups compress down to 100 GB.
The initial backup requires 400 GB with a 10 percent increase in the data each day. Each incremental backup is 200 GB. After data reduction, each incremental backup is 20 GB.
What is the weekly burn rate (GB) after six daily incremental backups and one weekly backup?

NO.41 An administrator wants to integrate a PowerProtect DD appliance into their current backup environment using CIFS, NFS, DD Boost, and VTL.
Which backup applications support these protocols?

NO.42 What are some possible network bottlenecks for a PowerProtect DD?

NO.43 A storage administrator finished the zoning between the PowerProtect DD and the NetWorker backup server.
How can they verify that the zoning was completed properly and the server HBA are visible?

NO.44 What system role is required to create the second security officer for a PowerProtect DD?

NO.45 Which protocol is used with Dell EMC Cloud Tier to transfer data between a PowerProtect DD appliance and the cloud?