100% Real & Accurate CTFL_001 Questions and Answers with Free and Fast Updates [Q14-Q38]

QUESTION 14
Typically, exit criteria may consist of:

QUESTION 15
In a system designed to work out the employee tax to be paid:
_ An employee has $4,000 of salary tax free. _ The next $1,500 is taxed at 10%. _ The next $28,000 after that is taxed at 22%. _ Any further amount is taxed at 40%.
Which of these is a valid Boundary Value Analysis test case?

QUESTION 16
You have investigated different possibilities and selected four of them to present to IT management.
Which of the proposals will you most likely give your highest recommendations?

QUESTION 17
A booking system for a city bus service prices its fares according to the time of travel:
* Peak-time tariff starts at 0600 and finishes at 1000 am
* Off-peak tariff applies during all other times of service
* The bus service does not operate between 2300 and the start of the next day’s peak service
Note that all times mentioned are inclusive.
When applying the equivalence partitioning test design technique, which of the following options, shows test case inputs that each fall into a different equivalence partition?

QUESTION 18
The test improvement project will take place in an organization developing a safety-critical avionics application. Which one of the following standards do you believe would be most appropriate to take into account for compliance during your assignment? 1 credit

QUESTION 19
IEEE 1028 also defines “management review” as a type of review. What is the main purpose of a management review? 1 credit

QUESTION 20
What is a test condition?

QUESTION 21
Which TWO of the review types below are the BEST fitted (most adequate) options to choose for reviewing safety critical components in a software project? Select 2 options.

QUESTION 22
Which of the following BEST defines static techniques?

QUESTION 23
Which activities form part of test planning?
i) Developing test cases.
ii) Defining the overall approach to testing.
iii) Assigning resources.
iv) Building the test environment.
v) Writing test conditions.

QUESTION 24
Which of the following are examples of iterative development models?
(i) V-model
(ii) Rapid Application Development model
(iii) Waterfall model
(iv) Agile development model

QUESTION 25
Designing the test environment set-up and identifying any required infrastructure and tools are a part of which phase:

QUESTION 26
A number of options have been suggested for the level of independence to be employed for the testing on the next project, and are shown below.
i. External test specialists perform non-functional testing.
ii. Testing is outsourced.
iii. Testing is carried out by the developer.
iv. A separate test team carries out the testing.
v. Testing is performed by the business.
vi. Testing is performed by a different developer.
Which of the following orders the above in a correct order of independence?

QUESTION 27
What is the purpose of a test completion criterion?

QUESTION 28
Which is not the fundamental test process?

QUESTION 29
One of the roles in a review is that of moderator, which of the following best describes this role?

QUESTION 30
Consider the following pseudo code:
1 Begin
2 Read Time
3 If Time < 12 Then
4 Print(Time, “am”)
5 Endif
6 If Time > 12 Then
7 Print(Time −12, “pm”)
8 Endif
9 If Time = 12 Then
10 Print (Time, “noon”)
11 Endif
12 End
How many test cases are needed to achieve 100 per cent decision coverage?

QUESTION 31
Which of the following would be a good test technique to use when under severe time pressure?

QUESTION 32
The effect of testing is to:

QUESTION 33
Which from the following list are typically found to enable the review process to be successful?
a. Each review has clear defined objectives
b. The lower the number of defects, the better the review process
c. The right people for the review objective are involved
d. There is an emphasis on learning and process improvement
e. Management are not involved in the process at all
f. Checklists should not be used, as these slow down the process
g. Defects found are welcomed and expressed objectively

QUESTION 34
Given is the following defect removal chart reported at the end of system testing – showing total defects detected and closed defects (fixed and successfully retested). A number of open defects are classified as critical. All tests have been executed.

Based on the chart above, what is the most appropriate next test phase? 1 credit

QUESTION 35
Pick the best definition of quality:

QUESTION 36
What is the main reason why reviews are especially beneficial in the above-mentioned scenario? 2 credits

QUESTION 37
Why is measurement of code coverage Important?

QUESTION 38
Risks should be constantly reviewed. Given the current situation, which one of the following factors is most likely to lead to a revised view of product risk?