This page was exported from Best Free Exam Guide [ http://free.exams4sures.com ] Export date:Fri Mar 14 21:07:28 2025 / +0000 GMT ___________________________________________________ Title: Cisco 200-301 Practice Test Pdf Exam Material [Q187-Q206] --------------------------------------------------- Cisco 200-301 Practice Test Pdf Exam Material 200-301 Answers 200-301 Free Demo Are Based On The Real Exam IP Connectivity This objective will test the configuration and verification of OSPFv2 and IPv6 and IPv4 static routing. It will also focus on the routing table, protocol of first-hop redundancy, and routing protocols. Which Jobs Are Associated with Cisco 200-301 Exam? Here are some of the most popular jobs that you can assume after attaining the new CCNA certification by acing the Cisco 200-301 test: Systems Administrator;Network Administrator;Network Engineer;Network Analyst. According to Payscale.com, the average yearly salary that CCNA certification holders can get is $78,768.   Q187. Refer to the exhibit.Which next-hop IP address does Routed use for packets destined to host 10 10.13.158?  10.10.10.5  10.10.11.2  10.10.12.2  10.10.10.9 Q188. Refer to the exhibit.An engineer has started to configure replacement switch SW1. To verify part of the configuration, the engineer issued the commands as shown and noticed that the entry for PC2 is missing. Which change must be applied to SW1 so that PC1 and PC2 communicate normally?         Q189. Drag and drop the characteristic from the left onto the IPv6 address type on the right. ExplanationQ190. Drag and drop the SNMP components from the left onto the descriptions on the right. Q191. Refer to the exhibit.When PC-A sends traffic to PC-B, which network component is in charge of receiving the packet from PC-A verifying the IP addresses, and forwarding the packet to PC-B?  Layer 2 switch  Router  Load balancer  firewall Q192. Drag and drop the TCP or UDP details from the left onto their corresponding protocols on the right. Q193. Drag and drop to the characteristics of networking from the left onto the correct networking types on the right. Q194. Which command enables HTTP access to the Cisco WLC?  config network secureweb enable  config certificate generate web admin  config network webmode enable  config network telnet enable Q195. Refer to the exhibit.What is a reason for poor performance on the network interface?  The interface is receiving excessive broadcast traffic.  The cable connection between the two devices is faulty.  The interface is operating at a different speed than the connected device.  The bandwidth setting of the interface is misconfigured Q196. Drag and drop the attack-mitigation techniques from the left onto the Types of attack that they mitigate on the right. Q197. Refer to the exhibit.A network engineer configures the Cisco WLC to authenticate local wireless clients against a RADIUS server Which task must be performed to complete the process?  Change the Server Status to Disabled  Select Enable next to Management  Select Enable next to Network User  Change the Support for CoA to Enabled. Q198. Drag and drop the DHCP snooping terms from the left onto the descriptions on the right. Q199. A network administrator creates a layer 3 EtherChannel, bundling four interfaces into channel group 1. On what interface is the IP address configured?  the port-channel 1 interface  the highest number member interface  all member interfaces  the lowest number member interface Q200. Drag and drop the WLAN components from the left onto the correct descriptions on the right. Q201. What are two roles of the Dynamic Host Configuration Protocol (DHCP)? (Choose two)  The DHCP server offers the ability to exclude specific IP addresses from a pool of IP addresses  The DHCP client can request up to four DNS server addresses  The DHCP server assigns IP addresses without requiring the client to renew them  The DHCP server leases client IP addresses dynamically.  The DHCP client maintains a pool of IP addresses it can assign. Q202. in Which way does a spine and-leaf architecture allow for scalability in a network when additional access ports are required?  A leaf switch can be added with connections to every spine switch  A leaf switch can be added with a single connection to a core spine switch.  A spine switch and a leaf switch can be added with redundant connections between them  A spine switch can be added with at least 40 GB uplinks Spine-leaf architecture is typically deployed as two layers: spines (such as an aggregation layer), and leaves (such as an access layer). Spine-leaf topologies provide high-bandwidth, low-latency, nonblocking server-to-server connectivity.Leaf (aggregation) switches are what provide devices access to the fabric (the network of spine and leaf switches) and are typically deployed at the top of the rack. Generally, devices connect to the leaf switches.Devices can include servers, Layer 4-7 services (firewalls and load balancers), and WAN or Internet routers. Leaf switches do not connect to other leaf switches. In spine-and-leaf architecture, every leaf should connect to every spine in a full mesh.Spine (aggregation) switches are used to connect to all leaf switches and are typically deployed at the end or middle of the row. Spine switches do not connect to other spine switches.Q203. An engineer needs to add an old switch back into a network. To prevent the switch from corrupting the VLAN database which action must be taken?  Add the switch in the VTP domain with a lower revision number  Add the switch with DTP set to dynamic desirable  Add the switch in the VTP domain with a higher revision number  Add the switch with DTP set to desirable Q204. Which security program element involves installing badge readers on data-center doors to allow workers to enter and exit based on their job roles?  role-based access control  biometrics  multifactor authentication  physical access control Q205. Drag and drop the attack-mitigation techniques from the left onto the Types of attack that they mitigate on the right. Q206. What is the purpose of a southbound API in a control based networking architecture?  Facilities communication between the controller and the applications  Facilities communication between the controller and the networking hardware  allows application developers to interact with the network  integrates a controller with other automation and orchestration tools. Explanationhttps://www.ciscopress.com/articles/article.asp?p=2995354&seqNum=2#:~:text=The%20Southbound%20Interfa The Southbound Interface In a controller-based network architecture, the controller needs to communicate to the networking devices. Loading … Cisco 200-301 exam covers a wide range of topics related to networking, including network fundamentals, network access, IP connectivity, IP services, security fundamentals, automation, and programmability. 200-301 exam includes multiple-choice questions, simulation questions, and drag-and-drop questions. 200-301 exam duration is 120 minutes, and the passing score is 825 out of 1000.   200-301 [Jan-2024] Newly Released] Exam Questions For You To Pass: https://www.exams4sures.com/Cisco/200-301-practice-exam-dumps.html --------------------------------------------------- Images: https://free.exams4sures.com/wp-content/plugins/watu/loading.gif https://free.exams4sures.com/wp-content/plugins/watu/loading.gif --------------------------------------------------- --------------------------------------------------- Post date: 2024-01-21 15:07:30 Post date GMT: 2024-01-21 15:07:30 Post modified date: 2024-01-21 15:07:30 Post modified date GMT: 2024-01-21 15:07:30