Q187. Refer to the exhibit.

Which next-hop IP address does Routed use for packets destined to host 10 10.13.158?

Q188. Refer to the exhibit.

An engineer has started to configure replacement switch SW1. To verify part of the configuration, the engineer issued the commands as shown and noticed that the entry for PC2 is missing. Which change must be applied to SW1 so that PC1 and PC2 communicate normally?

Q189. Drag and drop the characteristic from the left onto the IPv6 address type on the right.

Q190. Drag and drop the SNMP components from the left onto the descriptions on the right.

Q191. Refer to the exhibit.

When PC-A sends traffic to PC-B, which network component is in charge of receiving the packet from PC-A verifying the IP addresses, and forwarding the packet to PC-B?

Q192. Drag and drop the TCP or UDP details from the left onto their corresponding protocols on the right.

Q193. Drag and drop to the characteristics of networking from the left onto the correct networking types on the right.

Q194. Which command enables HTTP access to the Cisco WLC?

Q195. Refer to the exhibit.

What is a reason for poor performance on the network interface?

Q196. Drag and drop the attack-mitigation techniques from the left onto the Types of attack that they mitigate on the right.

Q197. Refer to the exhibit.

A network engineer configures the Cisco WLC to authenticate local wireless clients against a RADIUS server Which task must be performed to complete the process?

Q198. Drag and drop the DHCP snooping terms from the left onto the descriptions on the right.

Q199. A network administrator creates a layer 3 EtherChannel, bundling four interfaces into channel group 1. On what interface is the IP address configured?

Q200. Drag and drop the WLAN components from the left onto the correct descriptions on the right.

Q201. What are two roles of the Dynamic Host Configuration Protocol (DHCP)? (Choose two)

Q202. in Which way does a spine and-leaf architecture allow for scalability in a network when additional access ports are required?

Q203. An engineer needs to add an old switch back into a network. To prevent the switch from corrupting the VLAN database which action must be taken?

Q204. Which security program element involves installing badge readers on data-center doors to allow workers to enter and exit based on their job roles?

Q205. Drag and drop the attack-mitigation techniques from the left onto the Types of attack that they mitigate on the right.

Q206. What is the purpose of a southbound API in a control based networking architecture?