Pass Huawei H12-891_V1.0-ENU Exam With Practice Test Questions Dumps Bundle [Q306-Q328]

Q306. There is an existing router interface serial 0 in OSPF area 1, well will interface Serial 0 is set to silent interface.
So what is the impact of this setting?

Q307. Router HW enables OSPF and router HW has the role of ABR and is configured with abr-summary, so which class LSA Will it be aggregated? (Multi-select) (confirmed).

Q308. The router port to which the policy is applied has been idle for about 10 seconds, and there is a huge burst of c1 type coming in an instant, so how many bytes will the packets that are colored green?

Q309. LDP and IGP linkage refers to the release of IGP and TD routes to ensure that LDP and IGP linkage complete network efficiency, so that KGP and LDP maintains a consistent path, minimizing traffic loss, thereby improving the reliability of the entire network.

Q310. Regarding the BGP ring protection mechanism, the following description is correct?

Q311. One of the things you’re doing is compressing the length of ip6 addresses as much as possible . The existing IP6 address is
2013xX0C130F006009cO87641308, to be able to make this P6 address more concise, you can compress the IP6 address into which of the following? (Single choice questions).

Q312. Router HW1 and Router HW2 connect Network A and Network B, respectively. As shown in the figure below, if you want to set up an IPsec VPN between router HWI and router HW. (single selection).

Q313. MQC, like PBR-can only be called under the device’s Layer 3 interface.

Q314. Which nationality meets the following two conditions: 1] BGP Router A can choose whether the Ulpdate message is based on the nationality. ( )
If Router B receives a Updae message containing a cross-hatch, run-by B does not have an identified solidity, but will also contain a multifaceted] Ulpdate retracts the advertisement to Router C.
Router C may recognize and apply this attribute. (Multiple choice questions).

Q315. The Serial Number field of LS is used to detect expired and duplicate LSAs. The field is a 32bt signed integer, so the small serial number is Ox8000000

Q316. WRED is configured on the newly deployed router HW.
What is the correct description of the WRED features below? (Multiple choice questions).

Q317. There is an existing router running OSPF HWL, HW1 interface serial0 is published in zone 1, configure commands under the OSPF process nssa default-route-advertise, based on the previous description, infers which of the following options are correct?

Q318. In RSTP, which port provides a backup path to reach the root node of the spanning tree?
What state is the port in?

Q319. When deploying the ISIS protocol in an IPv6 environment, the following statement is correct (single choice).

Q320. The following statements about the VRRP protocol are correct (multiple choice).

Q321. The following link-LSA for OSPFv3 is correct?

Q322. What check frames can IPSG set?

Q323. In the forwarding table of the switch, a MAC address can correspond to only one outlet at a time

Q324. The router connects two EBGP neighbors through two parallel Serial cables, what do you do to achieve bidirectional negative sharing between two EBGP neighbors connected by these two parallel Serial cables? (Single choice questions).

Q325. The following statement about EVPN Type5 routing is wrong? (Single choice questions).

Q326. All interfaces of the router have OSPF enabled, the Cost value of the link is identified in the figure, and the Loopback0 socket for R2 is advertised in area 1, then Rl reaches 10022/32 with a Cost value of?

Q327. As shown below, what routes will R2 learn? (Single choice questions).

Q328. What are the common ways to learn routing in BGP? (Multi-select)