NO.101 You have a DHCP server on your MikroTik router. The IP addresses 10.1.2.2-10.2.2.20 are distributed in the DHCP network. Additionally, 3 static IP address are defined for your servers: 10.1.2.31-10.1.2.33.
After a while 20 more IP addresses need to be distributed in the network. It is possible to distribute the extra IP address without adding another DHCP Server:

NO.102 To block communications between wireless clients connected to the same access point interface, you should set

NO.103 When viewing the routes in Winbox, some routes will show “DAC” in the first column. These flags mean:

NO.104 What are the two main types of access control lists (ACLs)?
Standard
IEEE
Extended
Specialized

NO.105 If ARP=reply-only is configured on an interface, what will this interface do

NO.106 You want to use PCQ and allow 256k maximum download and upload for each client. Choose correct argument values for the required queue.

NO.107 What does the command routerA(config)#line cons 0 allow you to perform next?

NO.108 A PC with IP 192.168.1.2 can access internet, and static ARP has been set for that IP address on gateway.
When the PC Ethernet card failed, the user change it with a new card and set the same IP for it. What else should be done? [multiple answers]

NO.109 What menus should be used to allow certain websites to be accessed from behind a Hot-Spot interface, without client authentication

NO.110 Which features are removed when advanced-tools package is uninstalled?

NO.111 Which firewall chain should you use to filter clients HTTP traffic going through the router?

NO.112 If ARP=reply-only is configured on an interface, this interface will

NO.113 Please select valid scan-list values in interface wireless configuration:

NO.114 What protocols are used to configure trunking on a switch?
VLAN Trunking Protocol
VLAN
802.1Q
ISL

NO.115 Which of these are possible solutions to bridge two networks over a wireless link:

NO.116 Using wireless connect-list it’s possible to prioritize connection to one Access Point over another Access Point by changing the order of the entries.

NO.117 What is the correct action to be specified in the NAT rule to hide a private network when communicating to the outside world?

NO.118 Consider the following network diagram. In R1, you have the following configuration:
/ip route
add dst-address=192.168.1.0/24 gateway=192.168.99.2
/ip firewall nat
add chain=srcnat out-interface=Ether1 action=masquerade
On R2, if you wish to prevent all access to a server located at 192.168.1.10 from LAN1 devices, which of the following rules would be needed?

NO.119 Choose all valid hosts address range for subnet 15.242.55.62/27

NO.120 The highest queue priority is

NO.121 What command is used to create a backup configuration?