This page was exported from Best Free Exam Guide [ http://free.exams4sures.com ] Export date:Sat Mar 15 7:51:12 2025 / +0000 GMT ___________________________________________________ Title: 2022 Latest 100% Exam Passing Ratio - NCS-Core Dumps PDF [Q105-Q122] --------------------------------------------------- 2022 Latest 100% Exam Passing Ratio - NCS-Core Dumps PDF Pass Exam With Full Sureness - NCS-Core Dumps with 195 Questions NO.105 Refer to the exhibit.After performing ESXi to AHV conversion on a cluster, the alerts shown in the exhibit display on Prism. What should the administrator do to resolve this issue efficiently?  Remove the VMs. create a new Protection Domain, and add VMs to it  Remove VMs from the Protection Domain and add them back in.  Delete the Protection Domain, create a new Protection Domain, and add the VMs to it  Create a new Protection Domain and add the VMs to rt. NO.106 Over the period of 2 to 3 weeks, a cluster displays the following:*Periods where Warning Alerts of memory usage over 75% are asserted*Periods where Critical Warnings of memory usage over 90% are asserted*Periods of slow of frozen VDI desktops have caused work stoppage or slowdown*VDI clones have periodically not powered up when called, causing work stoppage Which steps should be used toprioritize the administrator’s troubleshooting efforts?  *Assess resource health on Hardware page*Review the Analysis page for memory usage demand*Determine the VDI workload-to-host affinity across the cluster  *Analyze Alert Pages for a root cause of memory problem*Analyze VM table page to access the VM functionality*Analyze the VDI Clone properties for possible VDI Workload stress  *Check Analysis page for CPU demand*Verify VDI workload property for memory subscription*Review theHardware page to determine if the cluster has sufficient RAM  *Review Analysis Page for memory use pattern*Alert with VDI workload demand*Analyze current and future workload in the Capacity Runaway tab for sufficient resources NO.107 A consultant is planning a new cluster installation and needs to locate the Shared IPMI port for each of the specific nodes that the customer has bought.Which Support Portal location contains the document that would identify the port?  Solutions Documentation  Hardware Replacement Documentation  Software Documentation  Knowledge Base NO.108 An administrator is updating disk firmware using LCM and receives the following message:“there have been 10 or more cluster services restarts within 15 minutes in the Controller VM” The message appears as each drive is upgraded.What is the reason this message isbeing generated?  A node has been rebalanced  A drive has been reformatted  A node has been rebooted  A drive has been ejected ExplanationRef: https://portal.nutanix.com/page/documents/kbs/details?targetId=kA032000000TT8DCAWNO.109 After finishing foundation on an AHV cluster, a consultant is preparing to plug into the customer network given the following set of requirements:* All network traffic on trunks is tagged* Customer is using LACP* A native VLAN is not in useWhich set of commands should the consultant use to ensure cluster connectivity on customer equipment?  change_cvm_vlan 0ovs-vsctl set port br0 tag=0ovs-vsctl set port br0-up bond_mode=balance-tcp  change_cvm_vlan 10ovs-vsctl set port br0 tag=10ovs-vsctl set port br0-up bond_mode=balance-tcp  change_cvm_vlan 0ovs~vsctl set port br0 tag=0ovs~vsctl set port br0-up bond_mode=active-backup  change_cvm_vlan 10ovs-vsctl set port br0 tag=10ovs-vsctl set port br0-up bond_mode=balance-slb NO.110 An administrator is deploying Nutanix Files 3.5 and needs to configure the sizing of the FSVMs for an increased number of concurrent SMB connections over the default 750.What should the administrator do?  Deploy the Files VMs.power down the three FSVMs. change the CPU and RAM via Prism, and then power the three FSVMs back up  During installation, click Customize on the File Server Installation screen, change the number of connections, and finish the installation  Complete the default installation change the CPU and RAM m Prism, and then log into the File Server dashboard and change the Filer Server Properties  During installation, input the correct number of connections in the File Server Installation screen and complete the installation ExplanationRef:https://portal.nutanix.com/page/documents/details?targetId=Files-v3_6:fil-file-server-manage-c.htmlNO.111 An administrator needs to deploy an application with a large amount of data connected via Nutanix Volumes.Which two actions should the administrator take when designing the Volume Group? (Choose two.)  Use multiple subnets for iSCSI traffic  Enable RSS (Receive Side Scaling)  Enable thick provisioning on the Volume Group(s)  Distribute workload across multiple virtual disks NO.112 Refer to the exhibit.A Microsoft SQL 2016 deployment is shown in the exhibit. The administrator receives user reports that database queries take too long to return.Which optimization should be made to this configuration to improve performance?  Combine both of the OS and SQL Binaries disks  Add a second SCSI controller for the Database.  TempDB, andLogs disk Separate the Database. TempDB, and Logs onto their own disks  Configure the VM to use a PCI disk controller NO.113 Anadministrator needs to evaluate if the existing configuration of Protection Domains meets the specified corporate recovery policy for SQL Data. The corporate policy requires that all SQL Servers be recoverable at the DR site within 30 minutes, and must result in a maximum of 60 minutes of data loss. SQL data must be required.The protection domain is configured as follows:* Application consistent snapshots are enabled* The SQL server VMs are assigned to the Protection Domain as their own Consistency Group* The Protection Domain schedule is configured as snapshots taken every 90 minutes from 7 am until 8 pm What must be changed to meet the required policy?  Revise the schedule tc be 15 minutes  Revise the schedule to be 60 minutes  Revise the schedule to be 30 minutes  Revise the schedule to be 45 minutes NO.114 A customer with a four-node RF2 cluster is addingapplication VMs to their system. After adding these VMs, the Prism dashboard shows 81% storage utilization.What is the consequence of running the cluster at 81% storage utilization?  The customer has the ability to add more VMs up to the 100% storage utilization.  There is available capacity in the storage fabric and the cluster is resilient.  Node failure is imminent due to storage utilization.  The cluster is not resilient in the storage fabric Explanationhttps://next.nutanix.com/how-it-works-22/recommended-maximum-storage-utilization-37234NO.115 The following alert appears on the file server alerts tab in the file server dashboard:Which two events can generate this alert? (choose two)  A three-node dusterhosting the file server is undergoing AOS upgrade.  A node failed in a three-node cluster.  A Nutanix file with four hie server VMs is deployed on a three-node duster.  A node is set to the maintenance mode in a three node cluster. NO.116 Refer to the exhibit.An administrator has an existing cluster and needs to improve performance using AHV Turbo. Which two items are required to achieve even greater performance? (Choose two.)  Workloads are multi-threaded.  VMs have one vCPU configured.  VMs have multi-queue disabled.  VMs have more than one vCPU. NO.117 A consultant is deploying a Nutanix cluster at a customer location. The consultant will be deploying the latest AOS along with the latest Nutanix hardware.Which three references should the consultant review prior to this installation? (Choose three.)  Release Notes  Software Product Interoperability  Field & Security Advisories  End-Of-Life (EOL) Information  Acropolis Advanced Administration Guide NO.118 An administrator has an existing Nutanix seven-nodecluster running at RF2 that must be changed to have the following capabilities:* RF3 set for the cluster* Performance tier deduplicationWhat is the minimum memory needed on the CVMs to allow for these capabilities?  24GB  28GB  32GB  20G? ExplanationRef:https://next.nutanix.com/how-it-works-22/rf2-rf3-requirements-37206#:~:text=Controller%20VMs%20mustNO.119 A consultant creates a Nutanix cluster using the 10.10.10.0/24 network and VLAN 10. The customer creates a VM network inside the Prism using VLAN 20. The customer starts to create VMs but is unable to ping the default gateway from these new systems.What is causing the issue?  The CVM/hypervisor must be on an untagged VLAN.  The switch port is not set up as a trunk.  Only one VLAN is supported on AHV.  The CVM/hypervisor cannot use the same VLAN as guest VMs. NO.120 A consultant is deploying a two-node cluster at a remote branch office.Which component must be available to complete cluster configuration?  Prism Central  Witness VM  Remote Site  Protection Domain NO.121 Refer to the exhibit.An administrator is commissioning a Nutanix Enterprise Cloud. Once the user VMs have been deployed and are running, the administrator finds that VMs on the same host are able to communicate, but are unable to communicate between hosts.What must be changed to enable full inter-VM communications?  Change the network the VMs are connected to  Change the spanning-tree port type on the switch  The VMs need to have static IPaddresses  Update the switch to specifically allow VLAN 15 ExplanationRef:https://hyperhci.com/2019/11/09/nutanix-ahv-enable-vlan-trunk-mode-on-guest-vm/NO.122 An administrator wants to utilize Network Visualization to monitor the physical and logical network on the Nutanix cluster. The first-hop switch has LLDP enabled. The network switch informationis still not being displayed.What is causing this problem?  The ISL between switches is not configured.  SNMP is not configured properly.  br0 and br1 are not defined.  The cluster is using RDMA-enabled NICs. Explanationref:https://portal.nutanix.com/page/documents/details?targetId=Web-Console-Guide-Prism-v55:wc-network-visu Loading … Verified NCS-Core dumps Q&As - 100% Pass from Exams4sures: https://www.exams4sures.com/Nutanix/NCS-Core-practice-exam-dumps.html --------------------------------------------------- Images: https://free.exams4sures.com/wp-content/plugins/watu/loading.gif https://free.exams4sures.com/wp-content/plugins/watu/loading.gif --------------------------------------------------- --------------------------------------------------- Post date: 2022-04-14 13:43:15 Post date GMT: 2022-04-14 13:43:15 Post modified date: 2022-04-14 13:43:15 Post modified date GMT: 2022-04-14 13:43:15