New DES-1241 Test Materials & Valid DES-1241 Test Engine [Q13-Q35]

NEW QUESTION 13
A Storage Administrator needs root access. What command needs to be run?

NEW QUESTION 14
Refer to the exhibit.

A Storage Administrator noticed a solid amber LED. What does this mean?

NEW QUESTION 15
Refer to the exhibit.

A Storage Administrator is troubleshooting a Dell EMC PowerStore T hardware issue. They observe that the base enclosure LED circled is blue. What does this indicate?

NEW QUESTION 16
What describes the power requirements for Dell EMC PowerStore?

NEW QUESTION 17
Which component is hot-swappable?

NEW QUESTION 18
A Storage Administrator notices two fans in a Dell EMC PowerStore are faulted. What describes the system behavior in this circumstance?

NEW QUESTION 19
What guidance must to be considered for Service LAN port access of a Dell EMC PowerStore appliance?

NEW QUESTION 20
What is the protocol used for the storage network?

NEW QUESTION 21
Match the correct non-disruptive upgrade process step (answer column) with the correct sub-step (match column).

NEW QUESTION 22
What is the last step when adding a drive to a Dell EMC PowerStore system?

NEW QUESTION 23
Correctly order the steps of the embedded module replacement procedure.

NEW QUESTION 24
What describes Dell EMC PowerStore X front-end cabling?

NEW QUESTION 25
What is the maximum number of base enclosures in a cluster when planning a Dell EMC PowerStore T installation?

NEW QUESTION 26
A Storage Administrator is adding an appliance into an existing Dell EMC PowerStore T cluster.
What is different about the management network configuration for the new appliance compared to configuring an initial appliance for the cluster?

NEW QUESTION 27
When connecting a PowerStore base enclosure to 2 expansion enclosures, match the base SAS ports in column A to their corresponding expansion LCC ports in column B.

NEW QUESTION 28
Which number in the code-naming schema represents a beta distribution?

NEW QUESTION 29
What is the maximum number of base enclosures in a cluster when planning a Dell EMC PowerStore T installation?

NEW QUESTION 30
When planning for a Dell EMC PowerStore T implementation, how many IP addresses are required for the storage network?

NEW QUESTION 31
What is the last step when adding a drive to a Dell EMC PowerStore system?

NEW QUESTION 32
For what is the “svc_container_mgmt status CP” command used?

NEW QUESTION 33
During an emergency event an ESD-Kit is unavailable for FRU replacement. How can the work proceed?

NEW QUESTION 34
Refer to the exhibit.

What is indicated when the circled LED on the node embedded module is illuminated solid amber?

NEW QUESTION 35
Through which network do external hosts connect to the cluster for data access?